To enter service mode, you have to turn the customer remote control to a service remote control,
To make the user remote control to a service remote control, cut off the portion just below the mode selector buttons to access the Service Button. Press this button once to Enter Service Mode.
TO INITIALIZE
- Turn the power on.
- To enter the service mode, press the service button on the service remote control unit.
- To cancel the service mode, Press [ POWER] button on the remote control.
- Press ( Information )button on the service remote control unit to initialize the LCD television.
- "INITIALIZED" will appear in the upper right of the screen. "INITIALIZED" color will change to green from red when initializing is complete.
PURITY CHECK MODE
This mode
cycles through full-screen displays of red, green, blue, and white to check for
non-active pixels.
- Enter the Service mode.
- Each time pressing [7] button on the service remote control unit, the display changes as stated above.
VCOM ADJUSTMENT
- Operate the unit for more than 20 minutes.
- Set the color analyzer and bring the optical receptor to the center on the LCD-Panel surface after zero point calibration.
Note: The optical receptor must be set perpendicularly to
the LCD Panel surface.
- Enter the Service mode.
- [VCOM1] - Press [2] button on the service remote control unit.
- [VCOM2] - Press [3] button on the service remote control unit.
- Press [UP / DN ] buttons on the service remote control unit so that the color analyzer value becomes minimum.
WHITE BALANCE ADJUSTMENT
- Enter the Service mode. Press [VOL DN] button on the service remote control unit and select “C/D” mode.
- [CUTOFF] - Press [3] button to select “COB” for Blue Cutoff adjustment. Press [1] button to select “COR” for Red Cutoff adjustment.
- [DRIVE] - Press [6] button to select “DB” for Blue Drive adjustment. Press [4] button to select “DR” for Red Drive adjustment.
- In each color mode, press [P UP / DN ] buttons to adjust the values of color.
For more Funai Model TVs details, check this
