Monday, December 31, 2012

LG 47LG90 _ T'CON [LCD CONTROLLER] BOARD REMOVAL





T-CON [TFT DRIVE PWB]



The T-Con IC UC2 receives from the Main Board at CN1 and CN2 Quadruple 12 Bit LVDS Signals which it processes into TFT Drive Signals which through connectors CN4 and CN5 controls the LCD Panel. IC’s U12 and U13 are “Dynamic Ram IC’s which are High Speed Storage Devices used to store the data until it is time to be addressed.
12V is supplied to the T-Con Board on connector CN1 from the Main Board.
NEW: This T-CON also drives the backlight LEDs in accordance to the necessary Light Source intensity according to the video content Contrast Ratio demands, (Local Dimming). Control signals to the Inverters are sent out CN8 and CN9.
Global Dimming pin 13 (Dig-DIM) input from Inverter M.  Controls brightness of LED backlights on both M and S Inverters.

T-CON [TFT DRIVE] PWB WITH SHIELD


T-CON [TFT DRIVE] PWB FUSE CHECKS

F1 (11.9V)
FL20 (1.6V)                                           T-Con. Part number EAT56803001
FL21 (3.3V)
FL22 (3.3V)
FL26 (3.3V)
FL27 (3.3V)

Gnd Protect.  Be sure to replace screws for ground purposes if turning on the set is required.
FL111
FL112
FL113
FL114
FL116
FL118

T-CON BWB REMOVAL

Look for Chocolate (Rubber like) Heat transfer material under shield. Always put back is same location.
Remove the 4 screws attached the T-Con shield in place.


Warning: The Tape shown is Conductive.  Do not allow to touch electrically charged components.


To remove the flex cables to the TFT Panel, CN4 or CN5: Place a soft sharp object like a fingernail underneath the black locking tab and gently lift upward.
Flip the lock up and back from the flex cable.  Then the flex cable can be easily removed.


To remove the LVDS cables for CN1 or CN2; Press in on the two tabs and slowly rock the cable out of the connector.  As shown by the arrows.


T-CON [TFT ] CN8/CN9 UNLOCKING