- Turn on your TV, VCR or Cable Box, depending on the device you are programming.
- Press TV* and release. Press and hold SETUP until the One For All® So Easy 3 Device's red light blinks twice. Release SETUP.
Note: When
setting up your VCR and/or Cable Box, substitute the appropriate device key
(VCR or CBL).
TV SETUP
- Aim the One For All® So Easy3 Device at your TV and press POWER. Your TV should turn off.
- If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your TV.
VCR SETUP
- Aim the One For All® So Easy3 Device at your VCR and press POWER. Your VCR should turn off.
- If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your VCR.
- If your original VCR remote did not have a POWER key, put a tape in your VCR and press PLAY on the One For All® So Easy3 Device.
CABLE SETUP
- Aim the One For All® So Easy 3 Device at your Cable Box and press POWER.
- Your Cable Box should turn off.
- If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your Cable Box.
- If your original Cable Box remote did not have a "ON" key, Use CH + on the One For All® So Easy 3 Device to turn your Cable Box on.
If
you cannot get the One For All® So Easy 3 Device to operate your
equipment or perform commands properly:
- Try all of the codes listed for your TV, VCR or Cable Box in the Set-Up Codes.
- Many set-up codes may allow partial functionality, however, only one code will operate your device correctly.
- Make sure you are within 15 feet of your equipment when using your remote control.
- If the red light on the remote control does not blink when you press a key, replace the batteries with two (2) new AAA alkaline batteries.
Be
sure you match the batteries to the plus (+) and minus (-) marks inside the
battery case.
- No volume when in the Cable mode or when operating a second TV or TV/VCR combination?
Press
and hold SETUP until
the red light blinks twice, then release SETUP. Press CH- /+ CH- /+ VOL- then
press VOL+.
