SANYO - LCD 42XR7H _ SOFTWARE UPGRADING

REQUIREMENTS

The FY* series models enable you to update software through the serial interface.

Hardware requirements:

One serial cable with female end and female end;

One PC set.

Install Gprobe 5.0: 

• The first: Double click the GProbe5[1].0.0.15_S0006-EXE-09A to install it.
• According to the prompt of Windows and follow the steps one by one to finish the installation.
• The second: Double click the GPorbe5[1].0.0.15Update1_S0006-EXE-10A to install it.

According to the prompt of Windows and follow the steps one by one to finish the installation.

1. Copy the full directory of Isp_fastflash to anywhere.  E.g. take the root directory of C:\ as an example for the following explanation:
2. Copy the updating file *.hex to the directory of C:\ Isp_fastflash\.  E.g. C:\ Isp_fastflash\20Y25.hex.
3. Open C:\ Isp_fastflash\Isp_parallel\ bat.txt as follows:

• Properly set the path of RAMWrite "C:\isp_fastflash\Isp_parallel\TEMP_OBJECT\isptemp_ parallel.hex" and FastFlashWrite "C:\isp_fastflash\20y25.hex", save them and close.
• Set the LCD to off. Connect the Y# updating board and PC with parallel cable.
• Connect the VGA MONITOR interface on the Y# updating board with the VGA cable, connect the other end to the VGA interface of the LCD.
• Turn on the LCD:  Double click to run Gprobe5.

• Click the icon.

• Set the Device to Parallel.
• Then click the item of Delays and Buffer Size:

• Set Long to 50000 ms.
• Click the item of Parallel:

• Set Clock to 120000 Hz.
• Click 'batch'

• Select path of the file: bat.txt
• Select bat.txt and click to open it:
  
  
  
  
  
• Click 'OK'.

• The following screen appears when the process if finished.

• If you want to update the software next time, you just need to click the pull-down menu to select the desired Batch file and execute it in the following screen.

Note: Do not cut off the power or turn off the unit during the burning process, or the flash may be damaged.

Check the following if you fail to update:

1. Check whether all cables are properly connected. If LCD is turn on.
2. Check the settings of Gprobe.
3. It is wrong if the Gprobe shows as the following icon.

• Now just click the icon to show below icon.