BACK COVER
- Remove [12] screws fixing the back cover. Tap the upper part of the back cover two or three times and pull the back cover to separate it from the unit.
TERMINAL BOARD
- Remove the four screws fixing the terminal board and the jacks. Lift fixing holder up, and pull the terminal board to separate it from the unit.
CHASSIS HOLDER
- Separate the assembly's' holder chassis from the Front cabinet. Pull the Chassis Holder lifting the fixing clip up.
- Separate the speakers, the side AV wire, the side control and the Remote Sensor cable from the Front cabinet, and the System Board.
- Separate the D-Coil and Power Cable from the Front cabinet and the Power Board. To separate power cord, slid the fixing clip and lift the cable up.
Separate the CRT Ass'y from the CRT. Separate the TBC wire, GND, VM & Tilst cables from the CRT Ass'y sentimentally.
CHASSIS HOLDER
- Separate the cables connecting the FBT and the CRT. NOTE: Since there may be remaining high-voltage current withing the CRT, take care not to touch the CRT final anode hole with metal or part of yourself when separating cables. Discharge the final anode charge if any, before trying to replace the final anode rubber boot. Take care.
CRT ASS'Y
- Separate the cables from the Deflection | System board and CRT ass'y.
- To separate the thick Red wire and White wire, pull the wires while pressing the push-type clip at the connector.
- To separate the thin Red wire, insert a pin in the small hold next to the hole, and pull the wire. Take care not to damage the socket while pulling out these cables.
DISASSEMBLING DEFLECTION BOARD.
- Separate the [28] pin cable from the System Board.
- Separate the [14] pin cable from the System Board.
- Separate the 14 pin cable from the Power Board.
- Separate the cable from splitter and the tuner.
- First separate the cable from the Splitter using a tool such as nippers.
- Remove 3 screws fixing the deflection ass'y
DISASSEMBLING POWER BOARD
Remove four screws to separate the holder fixing the deflection board holder.
- Separate the holder.
- Separate the cable from System Board.
- Remove two screws fixing the Power Board. Since there is a Holder fixing the Power Board, lift the part where screws have been installed and slide the board to separate it.
DISASSEMBLING THE SYSTEM BOARD
- Remove the three screws from the Bottom shield Case. Since the optical jack protrudes out of the case, lift the amp side up, slide and separate the board.
