SERVICE MODE ENTRY
- With remote control, switch the set to Standby.
- Switch OFF the set by mains Supply switch, and wait till the LED goes OFF.
- Press and Hold the "Magenta(text)" button on the remote control, switch ON the TV by its mains Power Switch.
- Continue pressing 'Magenta' button, until the Service Setup Sub-Menu appears.
=================================
ID 00.07
INT < >
STANDARD 00 0-03
=================================
NAVIGATION
- Press 'Up | Dn' buttons to select the menu line.
- Press ' < | > ' buttons to make adjustments or selection of a menu item.
Setup lines: {INIT, STANDARD, OSDCONTR}
Geometry lines: { HS, VS, VA, SC, VSH}
Video lines: {CL, BLORS/BLORP, BLOGS/BLOGP, WPPRS/WPRB, WPGS/WPBP, PWS/PWP, BKS, YD.
IF lines: (TOP)
Video processor: {CD0, CD1, SYN0, SYN1, DEF, V10, V11, SOUND, CONT0, CONT1, FEAT0}
ACTIVATION OF A LINE
The first line is continuously displayed. Sequential selection of others are possible by pressing the "Up | Dn" buttons on the remote control. Selected line will be hi-lighted in Yellow text.
ALIGNMENT AND STORING NEW FUNCTION VALUE
The current value of selected function is displayed in hexadecimal form to the right of the function name. This value is adjusted by " < \ > " buttons on the remote control.
The values will be stored in the non-volatile memory, when leaving the Service Menu.
To leave the Service Menu, press the 'Exit' button on the remote control.
TEMPORARY EXIT FROM SERVICE MODE.
To temporally leave the service mode, press 'Exit' button on the remote control unit. To access everyday menus, press Menu button on the remote control.
LEAVING THE SERVICE MODE
To leave the Service Mode, either switch the TV into 'Standby" or switch OFF the Mains Supply.
