PRESETTING BEFORE EX-FACTORY
Enter factory menu and select SSC
ADJUST, set SSC MIU and SSC LVDS to ON.
Enter
factory menu and select CUSTOM CHANNEL PRESET, press OK and about 10s the operation
will complete, press “list” and there are 5 channels in the list menu
Enter user menu LOCK page, select
“Restore Factory Default” to preset the ex-factory.
- Clear the program information.
- Clear VCHIP, parental control, etc.
- Set the default data of user menu.
- Set Menu Language to English.
- Set Power on Mode to Off.
SOFTWARE UPGRADING
Software writing and upgrade method with ISP
writing-device
- Main board upgrade: connect a four-pin wire of the ISP writing-device to Debug port(X806) on the main board; Unit upgrade: connect VGA ports of the ISP writing-device and the main board, enter factory menu and set “ISP Mode” to “ON”.
- Using Mstar writing-tool on line, click “Connect” menu, if it displays “Device EN25B32“ as shown in fig, the connection is success, if it fails, select “EN25B52” of “Device” manually and press “Connect” again.
- Click “Read” and select the file written (MERGE.bin for example) as shown in fig.
- Click “Auto”, select “All chip”, “program” and other items as shown if fig.
- Press “Run” to begin writing and there are two steps: Erase and Program.
- If the process of writing succeeds, it will display “Pass” near “Run” as shown in fig.
SOFTWARE WRITING AND UPGRADE METHOD WITH USB PORT
- Make sure the USB device is formatted as FAT32.
- Copy the program named Merge.bin to USB device.
- Insert the USB device to USB port of the unit, power on and select RF-ATV channel, begin USB upgrade after OSD disappear. It will display blue when read the data from USB device, while display red when write Flash. The flash must be pull out when display red. It will flicker in red and blue if the process of writing is abnormal.
- The method are not applicable to all the USB devices, try another one if a certain USB device is inapplicable.
