For easy servicing of a TV set, the set should be put face down on a soft flat surface, foam buffers or other specific workshop tools. Ensure that a stable situation is created to perform measurements and alignments. When using foam bars take care that these always support the cabinet and never only the display.
Caution: Failure to follow these guidelines can seriously damage the display. Ensure that ESD safe measures are taken.
- Assy/Panel Removal Van Gogh Styling (5000 series)
Rear Cover
Warning: Disconnect the mains power cord
before you remove the rear cover. Note: it
is not necessary to remove the stand while removing the
rear cover.
- Remove all screws of the rear cover.
- Lift the rear cover from the TV. Make sure that wires and flat coils are not damaged while lifting the rear cover from the set. Note: Some models come with mechanical catches at top of the rear cover.
- Lift the rear cover on the bottom [1].
- Push back the cover [2] to unlock the catches.
- If the rear cover catches still lock, place a flat screwdriver between flare and rear cover and turn it until the rear cover and the flare are disassembled from the catch.
- The location of the catches are indicated with [3], [4], [5] and [6].
Speakers
- Tweeters
- Subwoofer
MAIN POWER SUPPLY
- Unplug all connectors.
- Remove the fixation screws.
- Take the board out.
- When defective, replace the whole unit.
SSB [Small Signal Board]
- Unplug all connectors.
- Remove the fixation screws.
- Take the board out.
- When defective, replace the whole unit.
Mains Switch
- The mains switch is mounted on the front bezel with two screws.
IR & LED Board -2-
- Remove the stand.
- Remove the IR & LED board cover.
- Release the clips [3] that secure the IR & LED board.
- Remove the connectors on the IR/LED board.
Keyboard Control Board
- Unplug the connector on the IR & LED board that leads to the Keyboard Control board as described earlier.
- Release the cable from its clamps.
- Release the clip on top of the unit [1] and take the unit out. When defective, replace the whole unit.
Rear cover
Click on image. Click once more. If you still unable to read it; right click
on the enlarged image, save image as, to a folder. View it in ‘Picasa’ picture viewer. There you can enlarge it more. Download ‘Picasa-3’ by Google site, and
install it to your system. It’s free
software from Google and download it by Google. [Search for ‘Picasa’ by
Google]. Or, see this document in
Windows Picture – Fax Viewer.
