TO ENTER SERVICE MODE
This set has an On-screen Service Menu System included in the CPU that allows remote operation for most of
the service adjustments.
- Press and hold the MENU button on Side Controls.
- Keep pressing the MENU button and press the NUMERIC "1" button on the remote control, and the service mode menu will be displayed.
TO SELECT AND ADJUST AN ITEM
- Select “DATA” line by pressing ]Dn] or [Up] button.
- Press + or - button to adjust data.
TO EXIT SERVICE MODE
- Press MENU button on the Side Controls or remote control.
- Turn the TV off by pressing the POWER ON/OFF button on the Side Controls or remote control.
- The all adjusted data in service mode will be memorized into EEPROM automatically.
INITIAL DATA SETTING
This adjustment is controlled by the CPU (IC7200) through the
IIC Bus Data Line in the chassis, and those adjustment data are memorized the
memory IC (IC8002). Therefore, Main board or the memory IC (IC8002) is
replaced, these data will be disappeared. Readjust should be made. Initial data
is provided in the CPU ROM, when the memory IC (IC8002) is replaced with new
one. CPU ROM data is loaded into the memory. Initial data is provided to
operating the monitor basically. For operating the monitor quality performance,
further adjustment is required following chassis electrical adjustment.
- Receive good quality signal.
- Enter the Service Mode.
- Confirm data value to be the same as the Service Adjustment Data Table. If it is different, change to correct data.
- Exit the Service Mode.
WHITE BALANCE ADJUSTMENT
Pattern: White Pattern 100% (in AV mode).
Condition: Picture Mode: STANDARD
Color Temperature: NORMAL. Pre-heating Time: More than 10 minutes.
Adjustment
- Enter the Service Mode.
- Select "Source ALL" by pressing VOLUME UP or VOLUME DN button, and select "Properties White" by pressing VOLUME UP or VOLUME DN button.
- Set R,G,B value to “FF” by pressing NUMERIC buttons.
- To adjust Red : Press 1 (data value up) and 4 (data value down).
- To adjust Green : Press 2 (data value up) and 5 (data value down).
- To adjust Blue : Press 3 (data value up) and 6 (data value down).
- Decide one item in three items to a fixed value (For example, let R be fixed value), select item of other 2 colors (Example, G or B), and adjust to produce a normal black and white picture in highlight areas. (Note: At this time, Adjust the other 2 colors data less than fixed data.)
- Exit the Service Mode.
- After adjustment, confirm white balance again by normal picture.
