- Using the front control buttons with the set turned off (standby) can activate it.
- Press the SUB-POWER button, INPUT SELECT button and button at the same time, and hold for more than 5 seconds.
- The set turns on in adjustment mode with OSD.
CHANGING DATA AND SELECTING ADJUSTMENT CODE
- When the set is in adjustment mode, the cursor Left / Right; Up / Dn and OK buttons of the remote control or front panel may be used as the adjustment keys.
- Up / Dn buttons are used for selecting adjustment code.
- Left / Rightbuttons are used for changing data values.
- OK button is used for confirming the data.
- After finishing the necessary adjustment press MENU button. Adjustment mode is released and the set returns to normal condition
MEMORY INITIALIZE OPERATION
NOTE: The execution of
this function returns the adjustment codes to the preset values, therefore,
adjustment data will be lost.
Procedure
- Enter Adjustment Mode.
- Select MEMORY INIT adjustment code (No.658) and change the data value from 0 to 1.
- Activate MEMORY INIT by pressing OK button for more than 3 seconds.
- Select No.525 and change data value from 1 to 0.
- Check that the receiving channel goes to P1. Unit is set to preset value.
HOW TO RECOVER REMOTE AND FRONT KEY FUNCTION
- If remote and front key cannot operate after miss set special function by front keys, these functions can recover by below method.
- Press the SUB-POWER button, INPUT SELECT button and button at the same time, and hold for more than 5 seconds. The set turns on the service menu mode.
- Select No.535 and data set from [0] to [1].
- Press the SUB-POWER button and button at the same time, and hold for more than 5 seconds.
HOW TO GET TO BURN-IN MODE
This mode displays
the test patterns of some single color raster in turn. These signals are from
built-in generator of PDP panel. So it can be presumed that maybe the panel has
some trouble when the screen of Burn-in mode is abnormal.
Using the front
control buttons with the set turned off (standby) can activate this mode.
Press the SUB-POWER
button, INPUT SELECT button and VOLUME DOWN button at the same time, and hold
for more than 5 seconds. The set turns
on with single color raster and the OSD of [BURN IN: ON].
To escape from this
mode, press the SUB-POWER button, INPUT SELECT button and button at the same
time, and hold for more than 5 seconds. Burn-in mode will be released.
