LG - 50PQ3000-ZA _ PLASMA TV _ ADJUSTMENTS

POWER PCB ASSEMBLY VOLTAGE ADJUSTMENT

Va - ADJUSTMENT

Connect + terminal of D. M.M. to Va pin of P811, connect - terminal to GND pin of P811.

After turning VR901,voltage of D.M.M adjustment as same as Va voltage which on label of panel right/top (deviation;±0.5V).

Vs - ADJSUTMENT

Connect + terminal of D. M..M. to Vs pin of P811, connect -terminal to GND pin of P811.

After turning VR951, voltage of D.M.M adjustment as same as Vs voltage which on label of panel right/top (deviation ; ±0.5V).

[Va & Vs Voltages can be noted at the sticker label on the plasma panel]

SET INFORMATION [ SERIAL NUMBER & MODEL NAME]

• Push the menu button in DTV mode.
• Check the Serial Number.  Select the STATION ==> Diagnostics ==> To set.

CHECKING THE EYE-Q OPERATION

• Press the EYE Key on the adjustment remote controller.
• Check the Sensor DATA (It must be under 10) and keep the data longer than 1.5s
• Check ‘OK’

(Sensor DATA 0 ~ 4095, Power Saving Mode 0 ~ 12).  IF you press IN-STAP Button, change Green Eye-check OSD.

MANUAL WHITE BALANCE PROCESS [USING ADJUSTS REMOTE CONTROL]

Adjust in AV 1 MODE, Turn off Energy Saving Mode.

• Enter “PICTURE RESET” on Picture Mode, then turn off
• Fresh Contrast and Fresh colour in Advanced Control
• After enter Service Mode by pushing “ADJ” key,
• Enter White Pattern off of service mode, and change off -> on.
• Enter “W/B ADJUST” by pushing “G” key at “3. W/B ADJUST”.
• Adjust W/B DATA, for all CSM, choose ‘COPY ALL’

Gain Max Value is 192. So, Never make any Gain Value over 192 and please fix one Value on 192, between R, G and B.

DOWNLOAD SERIAL NUMBER [RS-232C]

1. Press “Power on” key of service R/C.(Baud rate : 115200 bps)
2. Connect RS232 Signal Cable to RS-232 Jack.
3. Write Serial number by use RS-232.
4. Must check the serial number at the Diagnostics of SET UP menu.

THE EXTENDED DISPLAY IDENTIFICATION DATA [EDID] DOWNLOAD

• Press the ADJ KEY on R/C and enter EZ ADJUST.
• Select “5.EDID D/L” by using D/E(CH +/-) and press ENTER(V).
• Select “Start” and press navigation key(G).
• EDID download is executed automatically.
• Press EXIT key on R/C

ANALOG RGB

HDMI