Monday, July 23, 2012

AIWA - TV F2400 SERVICE MODE



PREPARATIONS

     To enter service mode to this set, its original remote control should be modified.  The number of remote control for this model is [RC-6VT O6] [TV-CL42 | 86--LB4-951-010].  

     There is a 'finish' key, just left side of the "System" key, and a "Test" key just up to this 'system' key [Both these keys are hidden under the seal, and can be exposed by peeling out the seal temporarily]

SERVICE MODE ENTRY

  • Hidden key | "TEST"
  • Press the 'Test' key on the jig remote control once to enter the 'Aging' mode.
  • Press the 'Test' key on the jig remote control again to the 'Adjustment Mode'.
AGING MODE OPERATION METHOD.
  • Make sure that the confirmation is done after replacing the EEPROM.
<< TV-F 2400>>
  1. Enter to the aging mode by pressing the "Test" key on the remote control.
  2. Press the "System" key and confirm the condition of distinction switch.
Confirm the following items before doing the electrical adjustments.
  • In the case of contents are different, press [5] key and select (US25) for the destination.
  • In the case of data is different use the "Channel" key to scroll through [0->F], and set to the correct data value of "0" or "1" by the volume key.
  • All settings are stored when the "Test" key is pressed to complete the correction.
<<TV-F 2500>>

#  All the steps described above are the same to this model, except, for the step '1' ( In the case of contents are different, press "4" key, and select [NH25] for the destination.