Wednesday, July 25, 2012

DISNEY - DT1900C SERVICE MODE



TO ENTER SERVICE MODE

  • To enter service mode, press both "Set Key" and "Remote control key" for more than one second.
SET KEY => REMOTE KEY => OPERATIONS
  1. Volume Minimum => [0] => Releasing V-Chip password and Lock Password.
  2. Volume Minimum => [1] => Initialization of Factory.  Do not use this for normal servicing.
  3. Volume Minimum => [6] => Power On Total Hours will be displayed on screen.
  4. Volume Minimum => [9] => Display of Adjustment Menu on screen.
CONFIRMATION OF HOURS USED.
  • Set the Volume to Minimum.
  • Press both Volume Dn button on the TV, and channel button [6] on the remote control for more than 1 second.
  • After confirmation of hours, turn Off Power.
DISPLAY

INIT   00   00  >| Initial setting content of memory IC.
CRT  ON  0010 >| Power On Total Hours.  
|16*16*16*thousands digit value (+)|
|16*16*hundreds digit value (+)|
|16*tens digit value (+)| Ones digit value.

ADJUSTMENTS AFTER REPLACING MEMORY IC
  1. Enter Data Set mode by setting 'Volume" to minimum.
  2. While holding down 'Vol Dn' button on the front panel of the TV, press key [6] on the remote control for more than 1 second. 'Address' and 'Data' will appear.
  3. Addresses is now selected and should 'blink'.  Using Vol Up | Vol Dn button on the remote, step through addresses, until required address to be changed is reached.
  4. Press 'Enter' to select Data.  When Data is selected, it will start to blink.
  5. Again step through the Data, using Vol Up | Vol Dn until require Data Value has been selected.
  6. Pressing 'Enter' will take back to 'Address' for further selection if necessary.
  7. Repeat steps [3] to [6] until all data has been checked.
  8. When satisfied correct data has been entered, turn the Power Off to finish data input. 
After Data input, set to Initializing of shipping

  • Turn Power On.
  • While Holding down Volume button on the front of the cabinet, press key [1] on the remote control for more than 1 second.  
  • After finishing the initialization of shipping, the unit will turn Off Automatically.