Friday, July 20, 2012

SONY BLU-RAY PLAYER BDV-E780W E980W E985W SERVICE MODE


Part:1

SERVICE MODE

  1. Connect the unit with TV monitor.
  2. Press 'Power' button to turn the Power On.
  3. Press buttons in order of [Display => 0 => 2 => 1=> Subtitle], on the remote control.  [make the interval when each button is pressed within two seconds]
  4. Enter the 'BD' service mode.  The OSD menu on TV monitor can be operated by remote control.
MAIN FUNCTIONS
  • Diag:  Performs unit test of devices installed on board.
  • Display error log:  Error log is displayed.  Displayed contents can also be saved in an USB memory device.
  • Factory Initialize:  Restores the unit to its factory settings.
  • Network:  Checks the wired network connection.
  • Verson Up:  Not used.
  • System Information:  Displays system information of the unit.
  • EMC test mode:  Not used.
  • Drive:  Write drive OP data and check drive.
FACTORY INITILIAZE.
  • DISCONNECT THE FOLLOWING CONNECTIONS WHEN YOU USE THIS MODE.
  • Front USB.
  • Rear USB.
  • LAN.
  • HDMI IN-1
  • HDMI IN-2
Procedure
  1. Press the 'Power' button to turn the Power On.
  2. Press the 'Home' button on the remote control, and the home menu will be displayed.
  3. Select "Setup => Resetting" and press |+| button on the remote control
  4. Select 'Initialize personal Information', and press '|+|' button on the remote control.
  5. Select 'OK' and press '|+| button on the remote control.
  6. Select "OK' if you want proceed or select 'Cancel' if don't want.
COLD RESET

The cold reset clears data  except BD/DVD data stored in the RAM to initial conditions.  Execute this mode, when returning the unit to customer.
  1. Press Power button to turn Power ON.
  2. Touch the [black square] and [VOL-] sensors simultaneously and hold down more than 5 seconds.
  3. The message 'RESET' appears on fluorescent indicator tube, then becomes standby state.

Network operation method:  Cont: on part 2