Sunday, July 15, 2012

KONKA K1373UM SERVICE MODE MAIN POWER SMPS SCHEMATIC DIAGRAM




TO ENTER SERVICE MODE
  1. Press [Mute, Timer & Picture] buttons on the remote control in the order, within '2' seconds, to enter service mode.
  2. Press [P▲/▼”] buttons to select and item to adjust.
  3. Press [-▲/▼] buttons to change the data value to selected item.
  4. Press 'Menu' button to return to super menu.
  5. Under 'main menu' mode press 'Menu' button to 'Exit' form service menu mode.
AC power supply check and +B DC adjustment
  • Check  AC  power  supply  is  normal  or  not  (120V,  60Hz  and  Sine  Wave  are  normal)
  • Receive Television broadcast signal, set PICTURE to standard mode
  • Adjust RP950 so that voltages at two ends of C960 are +B.

Picture IF setting
Receive any signal, enter into VCJ    VCO  ADJà  VIF  VCO  AUTO  ADJ  menu under factory mode, then press VOL+/- button, when “END” displays on the screen, that means intermediate frequency has been adjusted to 45.75M in IC automatically.
RFAGC adjustment
Receive VH signal (Channel 7 or channel 10), apply 60dBμV gray scale signal
Enter  VDJ  ADJ à RF DELA Y ADJ  and  press  VOL“▲/▼”   button  to  adjust  it  until picture noise is just disappeared.
FOCUS adjustment
Receive five circles pattern, adjust the pattern to standard mode
Adjust  focus  potentiometer  (horizontal  output  transformer)  so  that  the center and four corners of pattern are the best focus.
Horizontal  scanning,  vertical  scanning  and  geometry  correction  adjustment
Receive  five  circles  pattern  signal,  enter  RASTER  ADJ  menu  to  adjust  the following parameters:
V POSITION Vertical Position
V SIZE Vertical Size
H POSITION Horizontal Position
Grid voltage adjustment and White Balance adjustment
Enter factory menu firstly and set PICTURE to STANDARD.
Enter into factory mode to set the following parameters:
PICTURE ADJ menu
SUB BRIGHTNESS 160
SUB CONTRAST 80
CRT ADJ menu
CUT OFF-R 127
CUT OFF-G 127
CUT OFF-B 127
DRIVE R 63
DRIVE B 63
Enter into  CRT  ADJ  menu,  press  0  button  to  display  one  horizontal  light line  on  the  screen,  adjust  grid  potentiometer  until  this  light  line  is  just
appeared. Press 0 button again to exit the horizontal light line status.  Insert  the  plug  for  automatic  adjustment,  running  white  balance  test program (WB37150.EXE)



SMPS SCHEMATIC [Click on picture to Enlarge]