Tuesday, July 31, 2012

SAMSUNG - CW29Z68PSG SERVICE MODE and ADJUSTMENTS



TO ENTER SERVICE MODE
  • Press {Power Off => Display => Menu => Mute => Power On} keys in sequence to enter service mode. 
WHITE BALANCE ADJUSTMENT
  • After enter the Service Mode, initilize all set data.
  • Input a Toshiba pattern.
  • Using Probe [CA100], do white balance adjustments.
TO ADJUST LOW-LIGHT
  1. Adjust sub-brightness to set 'Y"
  2. Adjust B-Cutoff to set 'y'
  3. Adjust R-Cutoff to set 'x'
TO ADJUST HI-LIGHT 
  1. Adjust sub-contrast to set 'Y'.
  2. Adjust B-Drive to set 'y'.
  3. Adjust R-Drive to set 'x'.
Check the value of low-light.  If necessary, adjust low-light.
Check the value of high-light.  If necessary, adjust hi-light .15.

SCREEN VOLTAGE ADJUSTMENT
  • Screen voltage and white balance are related each other.  Make sure, both these adjustments are correct.
  • Adjust screen voltage, before White Balance Adjustments.  Make sure the screen voltage is correct.
  • If white balance has been re-adjusted, re-check screen voltage too.
  • After adjustments has been done, check if there if spots appear on the screen after Power On/Off key.   If fly back line [thin white horizontal lines across the screen at about an inch apart, all over the screen], re-adjust the screen voltage to a little less.  It will be best to adjust screen voltage out from direct light.  A dark room is more preferable.