SHIVAKI - STV32L6 LCD TV SERVICE MODE SOFTWARE UPDATE

TO ENTER SERVICE MODE

• Under the ATV source;
• Press the 'GREEN' button on the remote control.
• Press 'SELECT' on the remote control for more than '5' seconds.
• Buttons to use to proceed are illustrated in the service menu display.

SOFTWARE UPDATE

• The software tool is used to upgrade the relevant model of [MST718BE] solution.  So it is unnecessary to install.  Open this software and then operate as follows.

Operation Steps

1. Connect the upgrade tool:  the parellel line, connect the PC parellel port, the VGA line connect to TV unit VGA port, and select the TV unit to 'ANALOGUE TV' source.  
2. After opening the Master ISP untility [V4.0.5] software, interface appears.
3. If it is for the first time to use this software tool, click 'Config' button.   Confirm whether the default configuration is correct.  If not, set up this configuration parameter.
4. Check the 'Device' button to select "Pm25LV040' device, and double click to confirm. 
5. After selecting the device, click 'Read' button to read the files that need to upgrade. 
6. After reading files, click 'Auto' button to confirm the parameter is correct.  If 'OK', click 'Run' button to upgrade the software. 
7. If the software update is not OK, click 'Run' button again to upgrade the software.