APPLICABLE TO: TX-L32U10B_TX-L32U10E_TX-L37U10B_TX-L37U10E
- While pressing "Volume -ve" button on the TV set, press button [0] on the remote control for "3" times, within "2" seconds.
- To "Exit" from service mode, press the 'Exit' button on the remote control.
Key Commands
- Press the [3 | 4] button to select the adjustment value function.
- Press [1 | 2] button to step Up \ Dn through the functions and adjustments.
- Press the numerical button "Volume (+ |-) to change the option item.
- Press "OK" button after each adjustment has been made to store the values in memory.
SELF CHECK
- Self-Check is used to automatically check the bus lines and hexadecimal code of the TV set.
- To enter self-check mode, keep pressing down (-/V) button on the TV set and press "Status" [i] button on the remote control.
- To exit self-check, switch Off the TV at the Power button.
POWER LED B LINKINGS
- When abnormality has occurred in the unit, protection circuit operates and reset to standby mode. At this time, the defective block can be identified by the number of blinkings of the Power LED on the front panel of the unit.
One continuous blink [4 seconds period] => Inverter SOS => LCD panel | A board.
Two blinks => FAN SOS => A Board.
Three Blinks => SOS = A board.
Four blinks => sub_F_12V => A Board.
Five Blinks => Main 9V => A board.
Six blinks => Sub 5V => A board | V board.
Seven blinks => Sub 3.3V => A board.
Eight blinks => main 3.3V => A Board.
Nine blinks => Sound SOS => A Board.
Thirteen [13] blinks => Emergency SOS => A Board.
