Saturday, July 21, 2012

NEC INTEGRA - PLA50V1 PLASMA TV METHOD OF ADJUSTMENTS -2


PART-2

ADJUSTMENT OF THE VIDEO SCREEN POSITION

  1. Enter an input of NTSC microscopic signal in the video input terminal.
  2. Select the 'Video' input by the use of relevant key on the remote control
  3. Enter the factory shipment mode by using factory shipment command of the remote.
  4. Press 'Proceed' key to obtain the [Position] screen.
  5. Press [Wide] key to select the [stadium] mode.  Stadium mode in the initial state.
  6. In case of any deviation from the display range of the PDP module, Press cursOr key 'Up' or 'Dn' of the remote control to select [MHPOS] or [MVPOS].  Press cursor key 'Right' of 'Left' for adjustments.
  7. Press cursor key Up or Dn of the remote to select [H-POS].
  8. Press cursor key Right or Left for adjustments so that the right and left are balanced.
  9. Press cursor key Up or Dn of the remote to select [V-POS].
  10. Press cursor key Left or Right of the remote for adjustment, so that the upper and lower are  balanced.
  11. Confirm that  [H-PHA] is maintained at '0'.
  12. Confirm that [H CLK] is maintained at '0'.
  13. In the same manner, press [Wide] key to select the 'Zoom' mode, the 'Normal' mode or the 'Full' mode.  Adjust the horizontal and vertical positions and confirm  that H-PHA and H CLK are maintained at '0', respectively.
  14. Change the input signal to PAL microscopic signal, and repeat the steps 4 to 14 above.
  15. Withdraw from Factory Mode.
ADJUSTMENT OF DVD/HD SCREEN POSITION

  1. Enter an input of HDTV monoscopic signal in the DVD/HD input terminal .  According to the 'convenient functional setting' in the 'Menu' screen, press cursor key Up of Dn of the remote control to confirm that [HD SELECT] has been set at [1035i].
  2. Select the HD input by the use of relevant key of the remote control.
  3. Enter the 'Factory Shipment' setting mode by using the factory shipment control command of the remote control.
  4. Press [PROCEED] key to obtain [POSITION] screen.
  5. In case of any deviation from the display range of the PDP module, press the cursor key Up or Dn on the remote control to select [MHPOS] or [MVPOS].  Press the cursor key Left or Right for adjustments.
  6. Press key Up or Dn of the remote control to select [H-POS].
  7. Press cursor key Right or Left for adjustment so that the right and left are balanced.
  8. Press cursor key Up or Dn of the remote control to select [V-POS].
  9. Press cursor key Right or Left for adjustment so that the upper or lower are balanced.
  10. Confirm that [H PHA] is maintained at '0'.
  11. Confirm that [H CLK] is maintained at '0'.
  12. Change the input video signal to NTSC  component signal, and repeat steps 3 to 11 of above.
  13. Change the input video signal to DTV1080i signal and repeat steps 3 to 11 above.
  14. Change the input video signal to the DTV1080i signal.  Press the cursor key Right or Left of the remote control to select [1080B] for [HDS] of the screen.  Repeat steps 3 to 11 above.  Return [HDS] to [1080i].
  15. Change the input video signal to the DTV 720P signal and repeat steps 3 to 11 above.
  16. Change the input video signal to the DTV 480P signal and repeat steps 3 to 11 above.
  17. Withdraw from the factory shipment setting mode.

End.