TO ENTER SERVICE MODE
This model's setting is adjusted in two different ways: through the I2C bus control and in the conventional analog manner. The adjustments via the I2C bus control include preset-only items and variable data.
CAUTION: MAKE SURE TV SET IN "NORMAL CONDITION" BEFORE
SWITCH TO SERVICE MODE FOR ADJUSTMENT.
SETTING THE SERVICE MODE BY THE MICROPROCESSOR
- Press SERVICE key on the remote controller to set the TV set to SERVICE mode position, and the microprocessor is in input mode. (Adjustment through the I2C bus control).
- Press the MENU key on the remote controller to get ready to select the mode. (Adjustment mode, Setting mode, Check mode and Option mode) one by one.
- Press the CH DOWN / UP key on the remote controller to select the item in Adjustment mode, Setting mode or Option mode.
- Using the VOLUME UP / DOWN key on the remote controller, the data can be modified. Please wait approximately 200 msec for data storage in EEPROM before select to another mode.
- In Check mode the data cannot be changed.
- Press the SERVICE key again, it will switch to the NORMAL mode position, and the microprocessor is out of the SERVICE mode.
FACTORY PRESETTING
- Power ON the TV set, press the SERVICE key on the remote controller, then press both the CH UP and VOL UP button on the set simultaneously for 5 seconds. Initial values are automatically preset, only when a new EEPROM is used.
- Make sure the data need modification or not (Initial data).
Precaution: If haven’t done this
initialization, it may possibly generate excessive Beam current.
While SERVICE mode ON, EEPROM DATA
will switch to the service data. Also, once SERVICE mode OFF, EEPROM will
switch back to previous USER DATA.
Set the MCL according to the specific
models.
MCL1 : 21K-FD5RU
MCL2 :
MCL3 :
MCL4
:
After set the MCL, set the INITIAL
SETTING for each models.
INITIAL 1 : For China ( All Channel
Sound System are set to D/K )
INITIAL 2 : For Hong Kong ( All
Channel Sound System are set to I )
INITIAL 3 : For Singapore, Africa and
Australia ( All Channel Sound System are set to B/G )
INITIAL 4 : For Middle-East ( All
Channel Sound System are set to B/G )
INITIAL 5: For Russia (All Channel
Sound System are set to D/K)
AFTER INITIALIZED THE EEPROM (REFER TO FACTORY
PRESETTING), READ DATA FROM EEPROM ADDRESS 00H ~ 03H,AND COMPARE TO THE LIST
BELOW, IF DIFFERENT, INITIALIZE THE EEPROM.
Address
|
Data
|
00H
|
7BH
|
01H
|
75H
|
02H
03H
|
78H
74H
|
There are five stages of service mode
data.
First stage data from V00~V31
(Adjustment Mode).
To go into second stage of service
mode data, press MENU key.Second stage data from F01~F298 (Setting Mode).
To go into third stage of service mode
data, press MENU key. Third stage data is Pixel mode setting.
To go into fourth stage of service
mode data, press MENU key.Fourth stage data is Check Mode.
To go into fifth stage of service mode
data, press MENU key.Fifth stage data from O01~O29 (Option Mode).
HOTEL MODE
When change service data (01) to (1), Hotel Mode is ON.
When Hotel Mode is ON:
- Max volume data is determined by option setting HTL-VOL (O03)
- Channel position after POWER ON is determined by option setting HOTEL-POS (O02) (if option setting HOTEL-POS is not set, processing is according to last position data).
- User data updates of EEPROM regarding the video and audio control are not allowed.
- Preset mode is disabling.
- CH SETTING menu is not available.
